According to the label From the product label

These details were extracted from this product's label PDF. The label is the law. Confirm every rate, site, restriction and safety requirement against the label before mixing or applying. Check for a state supplemental label; a product may be restricted or prohibited in a state or site even when a rate appears below. · EPA registration data for Reg. 100-1570 →

Talinor is a postemergence herbicide formulated as an Emulsifiable Concentrate (EC) designed for the control of broadleaf weeds in wheat and barley crops. It contains two active ingredients: Bicyclopyrone (3.41%) and Bromoxynil Octanoate (23.16%). The product works by inhibiting the 4-hydroxyphenyl-pyruvate dioxygenase (HPPD) site of action via bicyclopyrone and inhibiting photosynthesis via bromoxynil. It is intended for use in wheat, spring wheat, spring barley, and winter barley. Handling notes include a warning that the product contains petroleum distillates, which can cause aspiration pneumonia if swallowed. Users should follow specific resistance management principles, such as rotating herbicide modes of action, to prevent weed resistance. The label emphasizes thorough spray coverage for consistent control and provides detailed instructions for managing environmental hazards like groundwater and surface water runoff.

Pests covered (1)

broadleaf weeds

Areas treatable (1)

wheat and barley

Application instructions from the label 1

wheat and barley

Postemergence application; thorough spray coverage is essential for consistent control.

Target pest: broadleaf weeds
Location: Outdoor

Worker safety

PPE required Mixers, Loaders, Applicators, and other handlers must wear: long-sleeved shirt and long pants, shoes plus socks, and chemical-resistant gloves made of barrier laminate, butyl rubber ≥14 mils, nitrile rubber ≥14 mils, or Viton™ ≥14 mils.

Timing & weather

Avoid application when rainfall or irrigation is expected to occur within 48 hours to reduce surface water runoff risk.

Use restrictions 3

Do not apply directly to water, to areas where surface water is present, or to intertidal areas below the mean high water mark.
Do not contaminate water when disposing of equipment washwater or rinse.
Follow all Worker Protection Standard (WPS) requirements.

Catalog source document available. The local copy is still withheld until its exact product identity, role, and full file hash are accepted. Open the catalog source label ↗ and verify the product name, EPA registration number, and revision before relying on it.

Publication withheld. This catalog record has no active evidence summary, so its document and any extracted directions remain unavailable while identity and document role are reviewed.

Document text and citations

Extracted text is retained internally for document review and page-level citation checks. The complete third-party text is not republished here; use the document viewer above.

Reference only. Always read and follow the most current EPA-approved label on the product container. State and local restrictions may apply that are not reflected in this digitised copy. Verify the EPA registration number and revision date before use.