Aprovia

Syngenta · EPA Reg 100-1471 · Fungicide Document last checked 2026-05-30

According to the label From the product label

These details were extracted from this product's label PDF. The label is the law. Confirm every rate, site, restriction and safety requirement against the label before mixing or applying. Check for a state supplemental label; a product may be restricted or prohibited in a state or site even when a rate appears below. · EPA registration data for Reg. 100-1471 →

Aprovia is a broad-spectrum fungicide manufactured by Syngenta, used for the control of many important plant diseases. The active ingredient is Benzovindiflupyr (9.63%), formulated as an Emertible Concentrate (EC) containing 0.63 lb of benzovindiflupyr per gallon. It is primarily applied as a foliar spray and can be used in block, alternating spray, or tank-mix programs with other crop protection products. This product is suitable for various crops, including blueberries, grapes, small fruit vine climbing crops (subgroup 13-07F, except fuzzy kiwi fruit), and Pome Fruit Group 11-10. Application methods include ground and aerial sprays, as well as chemigation. When using this product, handlers must wear specific Personal Protective Equipment (PPE), including protective eyewear (goggles, face shield, or safety glasses), coveralls worn over short-sleeved shirts and short pants, chemical-resistant footwear plus socks, and chemical-resistant gloves (butyl rubber or nitrile rubber). A chemical-resistant apron is required when cleaning, mixing, or loading. Users should be aware of environmental hazards; do not apply directly to water or areas where surface water is present or to intertidal areas below the mean high water mark. To prevent runoff, maintain a 15-foot vegetated buffer strip between treated areas and surface water features like ponds or streams. Always follow the Worker Protection Standard (WPS) and observe the 12-hour restricted-entry interval (REI) after application.

Pests covered (1)

many important plant diseases

Areas treatable (1)

foliar spray

Application instructions from the label 1

foliar spray

Can be used in block, alternating spray, or tank-mix programs.

Target pest: many important plant diseases
Location: Outdoor

Mixing instructions 1

Label notes
Can be used in tank-mix programs with other crop protection products.

Worker safety

Re-entry interval (REI) 12

PPE required Protective eyewear (goggles, face shield, or safety glasses); Coveralls worn over short-sleeved shirt and short pants; Chemical-resistant footwear plus socks; Chemical-resistant gloves (butyl rubber or nitrile rubber); Chemical-resistant apron when cleaning, mixing or loading.

Timing & weather

Avoid application when rainfall or irrigation is expected to occur within 48 hours.

Use restrictions 4

DO NOT mix or allow to come in contact with oxidizing agents.
DO NOT apply directly to water or intertidal areas below mean high water mark.
Maintain a 15-foot vegetated buffer strip between treated areas and surface water features.
DO NOT cultivate within 15 feet of aquatic areas to allow for vegetated filter strip growth.

Label SDS

Catalog source document available. The local copy is still withheld until its exact product identity, role, and full file hash are accepted. Open the catalog source label ↗ and verify the product name, EPA registration number, and revision before relying on it.

Publication withheld. This catalog record has no active evidence summary, so its document and any extracted directions remain unavailable while identity and document role are reviewed.

Document text and citations

Extracted text is retained internally for document review and page-level citation checks. The complete third-party text is not republished here; use the document viewer above.

Reference only. Always read and follow the most current EPA-approved label on the product container. State and local restrictions may apply that are not reflected in this digitised copy. Verify the EPA registration number and revision date before use.