OxiDate 5.0 California

BioSafe · Hydrogen Peroxide · EPA Reg 70299-28 · Insecticide Document last checked 2026-05-30

← Back to OxiDate 5.0 California product overview

According to the label From the product label

These details were extracted from this product's label PDF. The label is the law. Confirm every rate, site, restriction and safety requirement against the label before mixing or applying. Check for a state supplemental label; a product may be restricted or prohibited in a state or site even when a rate appears below. · EPA registration data for Reg. 70299-28 →

Oxidate 5.0 is a broad-spectrum fungicide/bactericide formulated to control a wide variety of plant diseases. Its active ingredients are Hydrogen Peroxide (27.00%) and Peroxyacetic Acid (5.00%). It is used as a foliar spray, soil drench, or pre-plant application to manage various fungal and bacterial pathogens across diverse crops including vegetables, fruits, grains, ornamentals, and grasses. The product works on contact and is effective against diseases like powdery mildew, rust, blight, and rot. It can be applied via aerial spray, electrostatic spray, or ground equipment (sprinklers, air-blast, etc.). For best results, ensure thorough coverage and use clean water for dilution. Note that it is a strong oxidizing agent; avoid contact with eyes and skin, and use appropriate PPE. It is designed to be compatible with many pesticides, but users should perform a jar test before mixing with other chemicals. Always follow specific dilution rates based on the target crop and disease severity.

Pests covered (1)

Fungal and bacterial diseases (e.g., Rust, Blight, Powdery Mildew, Rot, etc.)

Areas treatable (1)

Foliar, soil, or seeds

How to treat each type of area 1

Foliar, soil, or seeds

Varies

Target pest	Location	Rate	Unit	Dilution	Label notes
Fungal and bacterial diseases (e.g., Rust, Blight, Powdery Mildew, Rot, etc.)	Both	Varies by crop/disease	N/A	1:256 to 1:500 depending on crop/disease	Use higher rates for fields with a history of disease.

Mixing instructions 1

For pests	Location	Amount	Per	Finished strength	Label notes
General foliar/soil application	Both	Varies	Varies	1:256 to 1:500	Perform a jar test before mixing with other pesticides, fertilizers, or adjuvants.

Worker safety

Re-entry interval (REI) 0

PPE required Long-sleeved shirt and long pants, chemical-resistant footwear plus socks, and protective eyewear (goggles or face shield).

Timing & weather

Begin applications when conditions favor disease development or at first sign/symptom of disease.
Avoid application if heavy rain is expected.

Use restrictions 3

Do not use in enclosed environments unless specific instructions are followed.
Do not use in a manner that contaminates water sources.
Follow Worker Protection Standard (WPS) requirements.

Label SDS

Catalog source document available. The local copy is still withheld until its exact product identity, role, and full file hash are accepted. Open the catalog source label ↗ and verify the product name, EPA registration number, and revision before relying on it.

Publication withheld. This catalog record has no active evidence summary, so its document and any extracted directions remain unavailable while identity and document role are reviewed.

Document text and citations

Extracted text is retained internally for document review and page-level citation checks. The complete third-party text is not republished here; use the document viewer above.

Reference only. Always read and follow the most current EPA-approved label on the product container. State and local restrictions may apply that are not reflected in this digitised copy. Verify the EPA registration number and revision date before use.