Chemicalsamvacscepter-t-o-70-wdg-herbicide

SCEPTER T&O 70 WDG Herbicide

AMVAC · EPA Reg 5481-613 · Herbicide Document last checked 2026-05-30

According to the label From the product label

These details were extracted from this product's label PDF. The label is the law. Confirm every rate, site, restriction and safety requirement against the label before mixing or applying. Check for a state supplemental label; a product may be restricted or prohibited in a state or site even when a rate appears below. · EPA registration data for Reg. 5481-613 →

Scepter T&O 70 WDG is a selective herbicide containing 70% imazaquin. It is designed for use on established lawns of Bermudagrass, St. Augustinegrass, Centipedegrass, and Zoysiagrass, as well as on golf courses, sod farms, commercial and residential turf, and selected landscape ornamentals. It controls a wide variety of weeds, including certain grasses, sedges, and broadleaf weeds such as crabgrass, nutsedge, dandelion, and clover. The product is applied as a water-dispersible granule (WDG) that is mixed with water and sprayed. It is effective against summer weeds and can be used for postemergence control of certain weeds in warm-season turfgrasses. Note that application timing is critical for certain weed types, and users should follow specific directions for weed resistance management. Always avoid application during temperature inversions or high wind speeds to prevent drift.

Pests covered (2)
Grasses, Sedges, and Broadleaf weedsBermudagrass
Areas treatable (1)
Established lawns (Bermudagrass, St. Augustinegrass, Centipedegrass, Zoysiagrass), Golf Courses, Sod Farms, Commercial/Residential Turf, and selected Landscape Ornamentals

How to treat each type of area 1

Established lawns (Bermudagrass, St. Augustinegrass, Centipedegrass, Zoysiagrass), Golf Courses, Sod Farms, Commercial/Residential Turf, and selected Landscape Ornamentals

Target pest Location Rate Unit Label notes
Grasses, Sedges, and Broadleaf weeds Outdoor 0.2 to 0.26 oz per 1,000 sq. ft. oz For spot spraying, use 0.5 oz per 3 gallons of water.

Mixing instructions 1

For pests Amount Per Label notes
General application 0.2-0.26 oz 1,000 sq. ft. Fill spray tank one-half to three-quarters full with clean water. Agitate while adding amount of Scepter T&O 70 WDG. Then fill remainder of tank with water. Maintain agitation while spraying.

Worker safety

Re-entry interval (REI) 12
PPE required Long-sleeved shirt and long pants; Chemical resistant gloves of any waterproof material; Shoes plus socks. If contact occurs: wash hands before eating/drinking/smoking; remove contaminated clothing immediately.

Timing & weather

Use restrictions 14

Label SDS
Publication withheld. This catalog record has no active evidence summary, so its document and any extracted directions remain unavailable while identity and document role are reviewed.

Document text and citations

Extracted text is retained internally for document review and page-level citation checks. The complete third-party text is not republished here; use the document viewer above.
Reference only. Always read and follow the most current EPA-approved label on the product container. State and local restrictions may apply that are not reflected in this digitised copy. Verify the EPA registration number and revision date before use.