Registration, signal word, restricted-use status and approved use sites are sourced from the U.S. EPA pesticide registry. EPA Reg. No. 73079-12. View this product's label on the EPA ↗ (EPA copy accepted June 1, 2016)
CimeXa Insecticide Dust is a dust formulation used to control ants, cockroaches, firebrats, silverfish, spiders, and mites. It can be applied as a light, visible film of dust in cracks, crevices, wall voids, attics, and crawlspaces, or diluted with water and used as a spray, paint-on, or foam. When used in food handling or serving areas, it may only be applied as a crack and crevice treatment.
| Target pest | Indoor / Outdoor | Where on site | Rate | Dilution | Infestation level | Notes |
|---|---|---|---|---|---|---|
| Ants, Cockroaches, Firebrats, Silverfish, Spiders, Mites | Both | attics, crawl spaces, trash closets, utility closets, behind baseboards, around the perimeter of dropped ceilings, in hollow furniture legs; under and behind bedding, appliances and vending machines; in wall voids and voids under and behind cabinets, sinks and tubs; in drawer wells, garbage chutes, pipe chases, weep holes in brick or siding, elevator pits, around drains, around electrical conduits and in cracks and crevices where insects may harbor | 2 ounces | Apply a light, visible film. Focus application in areas where insects or their signs are seen. | ||
| Ants, Cockroaches, Firebrats, Silverfish, Spiders, Mites | Both | attics and crawlspaces | 1 lb | |||
| Ants, Cockroaches, Firebrats, Silverfish, Spiders, Mites | Both | general | 2 ounces | per 100 square feet | ||
| Ants, Cockroaches, Firebrats, Silverfish, Spiders, Mites | Both | general | up to 1 lb of product with 1 gallon of clean water | Liquid Application: may be used as a spray, paint on application, or foam. Apply approximately 1 quart of product/water slurry per 250 square feet of area to be treated. |
| For | Where | Amount | Per | Finished strength | Notes |
|---|---|---|---|---|---|
| Ants, Cockroaches, Firebrats, Silverfish, Spiders, Mites | up to 1 lb | 1 gallon of clean water | Apply approximately 1 quart of product/water slurry per 250 square feet of area to be treated. The product does not dissolve in water and will be left behind and visible after evaporation. |